Morning (Maintenance) Switch laser to 3MHz Switch machine operating rate to 5MHz

Afternoon TPS validation Machine setup for long bunch trains at 3MHz and 5Hz Energy: 1GeV

Night Machine tuning: aim for ≥1nC/bunch at 3MHz, 600us bunch trains

Morning Beam loading compensation setup Piezo tuner setup Measurements of ACC67 quench limits

Afternoon Pk/Ql studies at ≥3mA

Night 1. Continue Pk/Ql studies at 3mA/600us as needed 2. Injector matching for 2nC bunches, starting around 04:00 3. Parasitically, perform initial gradient limit measurements

Morning 1. Once injector matching is completed at 2nC, begin transporting 2nC bunches and long bunch trains to the end of the linac 2. Return to high gradient studies: measure gradient limits without beam, then measure with light beam loading

Afternoon Preparation for Klystron saturation / RF power overhead studies Pk/QL studies at ≥4mA

Night Machine tuning: aim for 2nC/bunch @ 3MHz, 600us bunch trains

Morning Test procedures for performing gradient scans (+/- few %) with 6mA and 600us bunch trains

Afternoon High gradient studies with light beam loading

Night Pk/Ql studies at 6mA and long bunch trains Set up for 8hr stable run with gradients close to quench and moderate beam loading

Morning 8hr stable run with high gradients and beam loading

Afternoon High gradient studies Set up for RF power overhead studies

Night RF power overhead studies

Morning Set up high gradient studies with heavy beam loading High gradient studies with heavy beam loading

Afternoon High gradient studies with heavy beam loading

Night High gradient studies with heavy beam loading